Filter
Top Products
Operation
You are now ready to enjoy the convenience and security of your
LRD 6699SWS. Please read this section of the Operating Guide carefully
to familiarize yourself with the basic operation of this unit.
Power On
Turn the Volume Control switch to turn power on. Once the Power-On
alert sounds, your LRD 6699SWS performs a six second self-test of all
circuits. The X-band alert sounds for two seconds while the Three-Color
LED illuminates red, and the Signal Meter LED lights. Next you will
hear the K-band, Ka-Super Wideband, Laser, and SWS alerts for one
second each. (The corresponding Three-Color LED, City/Highway,
Audio/Dimmer, and Mute indications also light.)
After the self-test, your detector sets the modes which were used last. If
this is the first time you have used your LRD 6699SWS, it should be set
for HWY use, and both the AUDIO and MUTE modes should be off.
If you experience any of these problems:
• Settings do not display
• The unit turns on and off intermittently
• An alert sounds too often for no reason
Check to make sure both ends of the power cord are tightly secured. If the
problems continue, refer to page 20, “Troubleshooting” for more
information.
Volume Control
Adjust the Volume to a
comfortable announcement/
alarm tone level for your
vehicle. The volume level
does not have any effect on
the unit’s sensitivity.
13
C:...lrd6699.vp
Fri Jun 12 12:56:04 1998
Color profile: Disabled
Composite Default screen