Filter
Top Products
Operation
You are now ready to enjoy the convenience and security of your
LRD 2200SWS. Please read this section of the Operating Guide carefully
to familiarize yourself with the basic operation of this unit.
Power On
Turn the Volume control to switch on the power. When you power up the
LRD 2200SWS, it performs a self-test of all its circuits. This test takes
about 5 seconds, during which you will hear the different alarm tones and
see all the LEDs. First, you will hear the X-band alarm for 2 seconds
while the X-band indicator, City, and Mute LEDs light. The test also
checks the signal meter LEDs. It is best to adjust the audible alarm during
the self-test. Next you’ll hear the K-band/SWS alarm,
Ka-SuperWideband alarm, and Laser alarm, each for 1 second, while the
corresponding signal indicator LED lights. (The power LED remains on
until you turn off the unit.) The LRD 2200SWS always turns on with its
last setting.
After the LRD 2200SWS confirms proper operation, the alert tones and
all LEDs, except the green Power LED, turn off. If the Power LED does
not light, check the cigarette lighter socket connection. If the unit turns on
and off intermittently, or the alert tone sounds too often for no reason,
check the power cord connection at both ends to be sure it is not loose.
Volume Control
Adjust the Volume control
to a comfortable alarm tone
level for your vehicle. The
volume level does not have
any effect on the unit’s
sensitivity.
Off
Increase
Volume
13