Filter
Top Products
REMOTE COMMANDS
Press To
0 Turn the Answer Machine off. The Answer Machine beeps and announces
“Answer Off”.
2 Play all messages. If no message is recorded, “You have no messages” is
announced.
3 Play new messages. When new messages are recorded, the Answer Machine
announces the number of new messages before playback. If no new message
is recorded, “You have no new messages” is announced.
4 Monitor the room where the Answer Machine is installed. The room is
monitored for 20 seconds. Press 4 again for another 20 seconds. You
can repeat this for as long as you like.
5 Delete all messages (except new messages). Press 1 after the Answer
Machine announce “Erase messages”, then the Answer Machine beeps.
6 Stop playback and message recording.
7 Record a memo.
8 Change OGM. After the Answer Machine beeps, begin your new OGM.
When you finish, press 6 . The Answer Machine beeps and replays.
8 Play OGM. If no OGM is recorded, “You have no announcement one”
is announced.
Disconnect Line
Skip the OGM Message
After you press 2 or 3 to play messages:
Press To
1 Replay the previous message
3 Skip to the next message
4 Replay the current message
5 Delete the current message
6 Stop message playback.
If the Answer
Machine is turned
off, Remote Access
Features are not
available.
*
#
Be sure to set each
digit within 8 sec-
onds. Otherwise,
you must start over
from Step 1.
6
2
1
0
DA069 V4 Qk 5/17/02 2:40 PM Page 10