Filter
Top Products
2005 CAMRY (EWD586U)
129
The automatic light control system works when the light control SW is turned to AUTO. The automatic light control sensor
detects the brightness around the vehicle. By this function, the system automatically turns the taillight and headlight on if the
brightness is below the regular level and turns the taillight and headlight off when the surroundings become brighter than the
regular level.
Body ECU
9–Ground : Approx. 12 volts with the ignition SW at ON or ST position
12, 24–Ground : Always continuity
1–Ground : Always approx. 12 volts
D6 Door Courtesy SW Front LH
1–Ground : Continuity with the driver’s door open
: Parts Location
Code See Page Code See Page Code See Page
A28 40 C11 40 J23 41
B7 B 40 D6 42
B8 C 40 J4 41
:
Relay Blocks
Code See Page Relay Blocks (Relay Block Location)
1 22 Engine Room R/B (Engine Compartment Left)
:
Junction Block and Wire Harness Connector
Code See Page Junction Block and Wire Harness (Connector Location)
1H 25 Engine Room Main Wire and Engine Room J/B (Engine Compartment Left)
2B 28 Instrument Panel Wire and Driver Side J/B (Lower Finish Panel)
2E
28
Engine Room Main Wire and Driver Side J/B (Lower Finish Panel)
2F
28 Engine Room Main Wire and Driver Side J/B (Lower Finish Panel)
2R 29 Instrument Panel Wire and Driver Side J/B (Lower Finish Panel)
:
Connector Joining Wire Harness and Wire Harness
Code See Page Joining Wire Harness and Wire Harness (Connector Location)
IC2 50 Instrument Panel Wire and Floor Wire (Left Kick Panel)
:
Ground Points
Code See Page Ground Points Location
II 50 Cowl Side Panel LH
IJ
50
Instrument Panel Brace LH
IK
50 Instrument Panel Brace LH
System Outline
Service Hints