Filter
Top Products
16 ‘05-‘06 Tacoma (W/O Hitch) - 3” Kit 5603
c. Install kit blocks (2” dia.) on frame mounts.
d. Lower bed onto kit blocks.
e. At front and mid bed mounts, install kit bolts
(M12-1.25 x 160mm) and factory captive wash-
ers. DO NOT TIGHTEN.
Kit Block
(2” Dia.)
Front Bed
Mount
Mid Bed Mount
Rear Bed Mount
Install Kit Bolts
At These Mounts
Kit Bolts
(M12-1.25 x 160mm)
f. At rear bed mount, install kit bolt (M12-1.25 x
180mm) and factory captive washer. DO NOT
TIGHTEN.
g. Repeat previous steps on driver side of bed.
h. Set bed-to-cab spacing according to previous
measurement.
i. Remove each kit bolt, one at a time, and apply a
few drops of kit Loctite® to threads. Install kit
bolt with factory captive washer.
Rear of Vehicle
1. With O.E. Trailer Hitch: Rear bumper
WARNING
The following procedure is intended only to enhance
the appearance of the vehicle. The rear bumper will no
longer be rated for towing of any kind. Towing with the
rear bumper after it has been lifted can result in death,
serious personal injury, or damage to the vehicle. Tow-
ing after the bumper has been lifted should be accom-
plished using a rated Class III receiver type hitch.
NOTE
Rear bumper installation requires kit# 5903.
Install Kit Bolt
At This Mount
Kit Bolt
(M12-1.25 x 180mm)