Filter
Top Products
14 ‘05-‘06 Tacoma (W/O Hitch) - 3” Kit 5603
f. Install factory front captive washer and a kit bolt
(3/8” x 8”) on core support cab mount. DO NOT
TIGHTEN.
g. Install factory mid captive washer and kit bolt
(M12-1.75 x 200mm) on cab mount. DO NOT
TIGHTEN.
h. Install factory rear captive washer and kit bolt
(M12-1.25 x 210mm) on cab mount. DO NOT
TIGHTEN.
Kit Bolt
(3/8” x 8”)
Front Cab Mount
Kit Bolt
(M12-1.75 x 200mm)
Mid Cab Mount
Kit Bolt
(M12-1.25 x 210mm)
Rear Cab Mount
3. Cab driver side
a. Repeat previous steps on driver side of cab.
b. Set cab-to-bed spacing according to previous
measurement.
c. Remove front core support cab mount kit bolts
(3/8” x 8”) and apply a few drops of kit Loctite®
to threads. Install kit bolts, factory captive wash-
ers, factory lower washers and kit nuts (3/8”
Nylock). Tighten kit bolts to 55 ft. lbs.
d. Remove mid cab mount kit bolts (M12-1.75 x
200mm) and apply a few drops of kit Loctite® to
threads. Install kit bolts, factory captive wash-
ers, factory lower washers and kit nuts (12mm
Nylock). Tighten kit bolts to 55 ft. lbs.
Kit Bolt
(3/8” x 8”),
Kit Nut
(3/8” Nylock),
Factory Captive
Washer & Lower
Washer
Front Cab Mount
Mid Cab Mount
Kit Bolt
(M12-1.75 x 200mm),
Kit Nut
(12mm Nylock),
Factory Captive
Washer & Lower
Washer