Filter
Top Products
6. Charging
1. Power Switch must be in the ‘off’ position.
2. Do not plug the charger into the outlet first, for safety reasons plug the charger cord into the scooter
first, then into a 110 V outlet.
3. Charge your scooter for 6-8 hours. The LED will be red during charging and once it is fully complete
the LED will turn to green.
4. Do not overcharge you battery this may limit the life of your battery. Unplug after 8 hours to avoid
overheating.
5. Charge unit when a yellow or red light appears and every 90 days.
Battery Instructions
1. Battery is sealed leas acid; if there are any cracks or leaks in the battery, change the battery and dispose
of according to the laws in your area. Do not touch battery solution, if you do flush the affected area
with water. If you must come in contact with battery wear gloves.
2. Change the battery if there are any leaks, visible breaks or cracks.
3. Dispose of the battery according to your state and local laws.
First Remove the Deck Lift Out and Change the Battery
Fold Handle Bars Down
1. Unscrew the Handle Bar Quick Release.
2. Lay the Handle Bar down on top of the deck.
3. To protect the Grips from potential damage unscrew the bolts on the ‘T’ of the Handle Bar and lay the
Grips down.
Maintenance
1. Inspect your scooter before every use; check the brake, throttle, drive belt, and tires. Make sure that all
parts are in working order and are not damaged.
2. Clean your scooter regularly by wiping it down with a damp rag.
3. Lubricate the front and rear axle with WD-40. Do not lubricate the Bearings.
4. Lubricate the chain with chain grease that you can find at your local bicycle shop. Do this once every
month.
7