TeleType Company 3100 GPS Receiver User Manual


 
© 2007 TeleType Co.
WorldNav 3100
108
the second screen, press <Clear Route>.
Alternatively, use the <New Route> feature to
create a new route; the old route will be cleared
from the display automatically.
7.
What if the GPS can't locate my destination
address?
Some addresses may not be listed.
Change the route to locate the nearest
intersection, or nearest town instead.
8.
What if it seems the device is not showing my
true location?
Sometimes, the device takes a
few minutes to lock in on the satellite signal, after
which your true location will be shown.
9.
I can't get power on my car adapter.
If you can
get power on the 110V cable but not in your car,
it is likely that the fuse inside the adapter is
blown. Twist to unscrew the cover (the part that
sticks into the lighter) and replace the fuse with a
fresh one.
10.
My device is making a buzzing noise and is
difficult to power up. How can I get the GPS
to turn on?
This may occur if the 3100 battery
dips below 15%. Follow this procedure to correct
the situation:
1.Remove SD card (by gently pressing the card
into the device, it will then spring back out).
2.Connect the 12v power cord provided with the
device while the motor is running in your car.
3.Press Reset (found on the back of the