Filter
Top Products
5-27
OTHER CONTROLS AND EQUIPMENT
66J22-03E
Gate Operator / Canadian Program-
ming
Canadian radio-frequency laws require
transmitter signals to “time-out” (or quit)
after several seconds of transmission –
which may not be long enough for
HomeLink
®
to pick up the signal during
programming. Similar to this Canadian law,
some U.S. gate operators are designed to
“time-out” in the same manner.
If you live in Canada or you are having dif-
ficulties programming a gate operator by
using the Programming procedures
(regardless of where you live), replace
“Programming HomeLink
®
” step 3) with
the following:
NOTE:
If programming a garage door opener or
gate operator, it is advised to unplug the
device during the “cycling” process to pre-
vent possible overheating.
3) Continue to press and hold the
HomeLink
®
button while you press and
release – every two seconds (“cycle”)
your hand-held transmitter until the fre-
quency signal has successfully been
accepted by HomeLink
®
. (The indicator
light will flash slowly and then rapidly.)
Proceed with “Programming HomeLink
®
”
step 4) to complete.
Using HomeLink
®
To operate, simply press and release the
programmed HomeLink
®
button. Activation
will now occur for the trained device (i.e.
garage door opener, gate operator, secu-
rity system, entry door lock, home/office
lighting, etc.). For convenience, the hand-
held transmitter of the device may also be
used at any time. In the event that there
are still programming difficulties or ques-
tions, contact HomeLink
®
at
www.homelink.com
or 1-800-355-3515.
Erasing HomeLink
®
Buttons
To erase programming from the three but-
tons (individual buttons cannot be erased
but can be “reprogrammed” as outlined
below), follow the step noted:
Press and hold the two outer HomeLink
®
buttons until the indicator light begins to
flash-after 20 seconds. Release both but-
tons. Do not hold for longer that 30 sec-
onds. HomeLink
®
is now in the train (or
learning) mode and can be programmed at
any time beginning with “Programming
HomeLink
®
” – step 2).
Reprogramming a Single
HomeLink
®
Button
To program a device to HomeLink
®
using a
HomeLink
®
button previously trained, fol-
low these steps:
1) Press and hold the desired HomeLink
®
button. DO NOT release the button.
2) The indicator light will begin to flash
after 20 seconds. Without releasing the
HomeLink
®
button, proceed with “Pro-
gramming HomeLink
®
” – step 2).
For questions or comments, contact
HomeLink
®
at www.homelink.com or 1-
800-355-3515.