Filter
Top Products
5-25
OTHER CONTROLS AND EQUIPMENT
66J22-03E
HomeLink
®
(if equipped)
66J092
HomeLink
®
and the HomeLink
®
house are
registered trademarks of Johnson
Controls, Inc.
The HomeLink
®
Wireless Control System
provides a convenient way to replace up to
three hand-held radio-frequency (RF)
transmitters used to activate devices such
as gate operators, garage door openers,
entry door locks, security systems, even
home lighting. Additional HomeLink
®
infor-
mation can be found on the Internet at
www.homelink.com
or by calling 1-800-
355-3515.
Before programming HomeLink
®
to a
garage door opener or gate operator,
make sure that people and objects are out
of the way of the device to prevent poten-
tial harm or damage. When programming a
garage door opener, it is advised to park
outside of the garage. Do not use
HomeLink
®
with any garage door opener
that lacks safety stop and reverse features
as required by U.S. federal safety stan-
dards (this includes any garage door
opener model manufactured before April 1,
1982). A garage door that cannot detect an
object – signaling the door to stop and
reverse – does not meet current U.S. fed-
eral safety standards. For more informa-
tion, contact HomeLink
®
at
www.homelink.com or by calling 1-800-
355-3515.
Retain the original transmitter of the RF
device you are programming for use in
other vehicles as well as for future
HomeLink
®
programming. It is also sug-
gested that upon the sale of the vehicle,
the programmed HomeLink
®
buttons be
erased for security purposes. Refer to
“Programming HomeLink
®
” (step 1) only)
or, for assistance, contact HomeLink
®
at
www.homelink.com or by calling 1-800-
355-3515.
Programming HomeLink
®
NOTE:
Some vehicles may require the ignition
switch to be turned to the second (or
“accessories”) position or the “on” position
for programming and/or operation of
HomeLink
®
. It is also recommended that a
new battery be placed in the hand-held
transmitter of the device being pro-
grammed to HomeLink
®
for quicker train-
ing and accurate transmission of the radio-
frequency signal. Do not repeat “Program-
ming HomeLink
®
” – step 1) to train addi-
tional devices to a second or third
HomeLink
®
button. Begin with “Program-
ming HomeLink
®
” – step 2).
66J050
1) Press and hold the two outer
HomeLink
®
buttons (buttons one and
three) – releasing only when the indica-
tor light begins to flash (after 20 sec-
onds). Do not hold the buttons for
longer than 30 seconds and do not
repeat step 1) to program a second
and/or third hand-held transmitter to the
remaining two HomeLink
®
buttons.
2) Position the end of your hand-held
transmitter 5–14 cm (1–3 inches) away
from the HomeLink
®
button you wish to
program while keeping the indicator
light in view.
3) Simultaneously press and hold both the
chosen HomeLink
®
and hand-held
transmitter buttons. Do not release the
buttons until step 4) has been com-
pleted.
HomeLink: