Filter
Top Products
3-4
OPERATING YOUR VEHICLE
57L20-03E
Keyless Push Start System
Provided the keyless start system remote
controller is within the “interior workable
area” (Refer to the related explanation in
this section), you can use the engine
switch for starting the engine and selecting
a power supply mode (“ACC” or “ON”). In
addition, the following functions can be
used:
• Keyless entry function. Refer to “Keyless
Start System Remote Controller” in the
“Before Driving” section for details.
• Locking and unlocking doors using a
request switch. Refer to “Keyless Start
System Remote Controller” in the
“Before Driving” section for details.
• Opening the trunk lid from outside using
the trunk lid request switch.
• Immobilizer (anti-theft) function. Refer to
“Immobilizer System” in the “Before Driv-
ing” section for details.
Engine Switch Illumination
The engine switch is illuminated lit in the
following situations:
• The driver’s door is open (only when the
engine is not in operation).
• For 15 seconds after the driver’s door is
closed (only when the engine is not in
operation).
• The position lights are on.
The illumination will fade out when it is not
required.
82K253
NOTE:
To save the battery, the illumination will be
automatically turned off when both of the
following conditions are simultaneously
met (battery saver function):
• The headlights and position lights are
turned off.
• A period of 15 minutes has elapsed after
opening the driver’s door.
Selection of Power Supply Modes
Press the engine switch to select the
“ACC” or “ON” mode as follows when you
use an electric accessory or check the
operation of instruments without running
the engine.
1) Bring the keyless start system remote
controller with you and sit in the driver’s
seat.
2) Without depressing the brake pedal,
press the engine switch (1).
82K254
Every time you push the engine switch
without the brake pedal depressed, the
power supply mode changes as follows.
(1)
Lighting/Turn Signal Control Lever: 8
Windshield Wiper and Washer Lever: 8