Filter
Top Products
IMPREZA U.S.A. (E)
6-18
1) Press the “ADJ” switch for 5 seconds or more.
2) Press the “YSET” or “B” to obtain the correct setting.
“YSET”: “0” & “W”, “5” & “E”, “10” & “E”, ...
“B”: “10” & “W” → “15” & “W”, ...
3) Press the “ADJ” switch again to save the setting and return the
system to the original display.
2. Direction setting
If the vehicle icon is blinking at any time, the following adjustment is
required to recalibrate the compass.
NOTE
This will happen due to the magnetic field interference as described
previously.
HS6011BBHS6010BA
1) Press the “ADJ” switch for the compass setting mode.
NOTE
D The compass starts blinking in this mode.
D This mode can be canceled by pressing the “ADJ” switch again.
2) Make certain that it is safe to do so and then drive the vehicle in a
circle until the compass stops blinking. You may have to complete
more than one circle to perform this calibration.
NOTE
D When setting is completed, all blinking disappears.
D The setting mode is automatically cancelled if the “ADJ” switch is
pressed in the middle of setting or if the setting is not completed
within 2 minutes.