Filter
Top Products
IMPORTANT BATTERYINFORMATION:
• Do not mix old and new batteries.
• Do not mix alkaline, standard or rechargeable batteries.
• Battery installation should be performed by an adult.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy before
being charged (if removable).
• Rechargeable batteries are only to be charged under adult
supervision.
• Only batteries of the same or equivalent type as
recommended are to be used.
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short circuited.
• Different types of batteries, or new and used batteries are
not to be mixed.
• Exhausted batteries are to be removed, as they will adversely
affect the performance.
Your Zero Gravity Micro™is equipped with a Lithium Polymer battery.
WARNING:
• Do not leave the toy unattended while charging it.
• Battery charging should be done by adults.
• Charge the toy on a non-flammable surface and keep it away from flammable items.
• Do not expose battery to direct sunlight. There is a risk of the battery exploding, overheating, or igniting.
• Do not disassemble, modify, heat, or short circuit the battery.
• Do not place battery in fires or leave in hot places.
• Do not drop or subject to strong impacts.
• Do not allow the battery to get wet.
• Only charge the battery with the specified Air Hogs
®
battery charger.
• Only use the battery in the device specified by Air Hogs
®
.
• Turn the charger off when the toy’s battery is charged, and always unplug it from the toy.
• Disconnect AC wall chargers from outlets while not in use.
• If the toy has been damaged, immediately stop use, unplug, and safely move the toy away from flammable materials.
• Follow the manufacturer’s instructions for charging the toy. Do not charge longer than recommended.
• Carefully read the instruction manual and use the battery correctly.
RIGHT SPIN
By pushing the joystick on the controller/charger, you can make your Wall Racer spin around on the spot.
Push the RIGHT joystick to the right to
make the vehicle spin clockwise.
Push the RIGHT joystick to the left make
the vehicle spin counter-clockwise.
SPINS
TROUBLESHOOTING
Spin Master Ltd., 450 Front Street West, Toronto, ON M5V 1B6 Canada
Spin Master Inc., PMB #10053, 300 International Drive, Suite 100, Williamsville,
NY 14221, USA
Spin Master Toys Far East Limited. Rm #1113, 11/F, Chinachem Golden Plaza,
77 Mody Rd., Tsimshatsui E., Kowloon, HK
Spin Master Toys UK Ltd., Meadowbank, Furlong Road, Bourne End, Bucks,
SL8 5AJ, United Kingdom
Spin Master France – 36 rue de Silly – 92100 Boulogne Billancourt – France
North American Consumer Information
Phone: 1-800-622-8339
www.spinmaster.com
TM and © 2008 Spin Master Ltd. Air Hogs ®is a
registered trademark of Spin Master Ltd. All rights
reserved. Conforms to product safety standards
ASTM F963, regulatory requirements. Products and
colors may vary. Please retain this information for
future reference. Patent Pending.
MADE IN CHINA.
Asst. #44317 NEN REV 1
PROBLEM
Vehicle will not run.
Vehicle does not climb.
Vehicle does not drive straight.
Vehicle slips climbing the walls.
Vehicle falls off the wall.
Vehicle will not climb walls.
SOLUTION
1. Power switch is off. Turn on.
2. Controller battery is installed with incorrect polarity. Check the (+) and (-) markings to make sure the
battery is properly aligned.
3. Batteries are drained. Charge batteries and/or install new batteries.
1. Over current protection is engaged. Turn vehicle off for 30 seconds then restart.
1. Check trim.
2. Make sure surface is clean of dirt/dust.
3. Make sure surface is neither too rough or too smooth.
4. Make sure surface is flat.
1. Clean the tires with a damp rag.
2. Fold up the fabric skirts for a better seal prior to use.
1. Make sure to discharge and then charge again for 30 to 50 minutes.
2. Clean tires and make sure your wall and floor are also clean.
3. Check the fabric skirts for damage. If they have been pulled loose, tape them back on with flexible tape.
4. Make sure surface is flat.
1. Suction jammed. CALL 1-800-622-8339.
TM
Contains LiPo battery
pack. Battery pack
must be recycled or
disposed of properly.
!
STILL HAVING PROBLEMS? Before you return to retailer, please call our HOTLINE for assistance,
1-800-622-8339
LEFT SPIN
Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures: • Reorient or relocated the receiving antenna. • Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. • Consult the dealer or an experienced radio/TV technician for help.
FCC REQUIREMENTS
This Class B digital apparatus complies with Canadian ICES-003.