Filter
Top Products
Straighten the
AIR TUBING.
STEP 5
IMPORTANT:
The non-flexible AIR TUBING must be completely
straight or the ROCKET will not launch.
Connector A
Air Tubing
LAUNCHER/
ACCUMULATOR
PUMPING STATION
Connector B
Connector C
Connector D
Connector E
LAUNCHING INSTRUCTIONS
STEP 2 STEP 3
Unclip
ROCKET
from its
ROCKET
HOLDER.
Place the
ROCKET
on the
LAUNCHER
SHAFT.
STEP 1
Push the
LAUNCHER
SHAFT down
until it
“CLICKS”.
Rocket
Holder
Push
Down
Launcher
Shaft
IMPORTANT:
• Before screwing together each CONNECTOR, be sure that the LAUNCH RELEASE CABLE
is tightened. Loose wire can be tightened by pulling the LAUNCH RELEASE HANDLE.
• For easier assembly, the AIR TUBING should be rotated when it is being inserted into the CONNECTOR.
ROTATE & PUSH!
STEP 6
Screw together
each of the
CONNECTORS
(A,B,C,D and E).
Connector
Air Tubing
1
2
SLIDE & SCREW TOGETHER!
Launcher
Shaft
Rocket
Shaft
STEP 4
Push the
ROCKET down
until the bottom
of the ROCKET
touches the
RED LINE.
IMPORTANT: If
ROCKET is not
pushed down all
the way, the
ROCKET WILL
NOT launch.
Push
Down