Filter
Top Products
(seeFig.1,2)
TOADDHYDRAULICJACKOIL
the oi_fill plug DO NOT ALLOW dirt o_debris to ente_ the system
TO REPLACE HYDRAULIC JACK OiL
° Open the release valve by pressing down on the re_ease peda_
Unscrew and remove oil fil_plug.
- Turn entire jack over so that a_ d the old oi_will drain out d the oi_fiHhole.
NOTE: When draining oil use a proof container and ALWAYS fo_ow ALL
local and state waste disposa_ guidelines
* After a_!of the oid oil has drained out d the jack, turn the _ack back e/vet to a
DO NOT ALLOW dirt and debris to enter the system
-Repiace and tighten oil fili piug.
iMPORTANT: When adding or replacing oH, ALWAYS use a goed
grade d (SAE 5 W) hydraulic jack oi_ NEVER use brake fluid, alcehoi
glycerin, detergent motor oi$or dirty oH d any kind Improper oit usage
will cause serious internal damage to jack.
LUBRICATION
, Use a good grade e_lubricating ell on a_ moving parts when needed
STORING
, When iack is not in use or when storing the jack,
ALWAYS have the lift saddles in the lowest (downi_position
RUST PREVENTION
Check power unit (hydrau}ic ram} see pa_s _istFig 2 _etter_) page 5
every two monfhs or sooner based on use for any rust or corrosion
Clean and wii_ down with oil cloth.