Filter
Top Products
Page 4 - Astra 7E7
To disable the auto activate function:
1. Press and hold Buttons 2 and 3 until the remote beeps four times.
· The fan and clock will be shown indicating timer is activated.
2. Press Button 1 to disable the timer.
· The remote will beep three times to indicate the timer has been disabled.
LCD Backlight
Transmitter Button 5 is used for confirmation, transmitter programming, as well as activation of
the LCD backlighting for use in the dark. Press button 5 to activate the LCD backlight.
System Confirmation
The 2-way transmitter's confirmation feature allows the current vehicle status to be displayed
at any time.
To display system status:
1. Press and hold Button 5 until the display shows CON.
· The transmitter will beep once.
2. Release Button 5.
· The transmitter will beep once.
· The icon representing the system’s current status will be displayed on the LCD panel.
Transmitter Programming
Pressing and holding transmitter button 5 will scroll through several transmitter programmable
options that may or may not be available depending on the model of system installed
DEG (degress)
Not applicable on this model.
CHP Sets the siren confirmation chirps ON or OFF:
1. Press and hold Button 5 until the display shows CHP.
·The transmitter will beep 3 times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will show a siren if the chirps are enabled or "off" if the chirps are
disabled.
SND Sound function Selects the transmitter's confirmation tones. (Beeps or Vibrate)
To turn the transmitter confirmation tones off:
1. Press and hold Button 5 until the display shows SND.
· The transmitter will beep four times.
2. Release Button 5.
· The transmitter will beep once.
· The LCD panel will vibrate and display “off” if the confirmation tones are disabled.
The Transmitter is now set to Vibrate for confirmation.
3. Repeat steps 1-2 to turn confirmation tones on again.
PSV Allows the passive arming mode to be enabled or disabled with the transmitter.
To enable or disable the passive arming mode:
1. Press and hold Button 5 until the display shows PSV.
· The transmitter will beep five times.
2. Release Button 5.
· The transmitter will beep once and the system will begin the passive arm mode
· The LCD panel will display “off” and vibrate twice if disabled.