Filter
Top Products
Page 40 - Precision Pro
9. Auxiliary 3 Mode. Selects from momentary, 10 second timed, or latched operation for Auxiliary 3.
Momentary operation provides an output for as long as the transmitter button is pressed.(1-way
remote only)
Timed operation provides an output that turns on for 10 seconds each time the transmitter button is
pressed. If the button is pressed again during the 30 seconds, the output will turn off.
Latched operation provides an output that turns on when the transmitter button is pressed and
remains on until the transmitter button is pressed again.
Note: With the optional ScyNet network interface and Wizard software, any auxiliary function can be
programmed to output for 1 second up to 255 seconds.
10. Unlock with Auxiliary 1. When selected, activating the Auxiliary 1 output (usually used to open
the trunk) will unlock the vehicle.
11. Aux 2 Auto Activate with Lock. When selected, the Auxiliary 2 output will activate when the
system is locked. This feature can be used to roll-up windows, close sunroofs, activate accessories,
etc.
12. Auxiliary 3 Output Mode. Selects between Channel 3, Factory Rearm output, or third Ignition
ouput.
13. Start in Valet Mode. Selects whether or not the vehicle can remote start while in the valet mode.
Using button 3 enables Mp Siren Mode.
14. Lock After Start. When selected, the doors will automatically lock after remote starting.
Using button 3 disabled Mp Siren Mode.
15. Lock After Shutdown. When selected, the doors will automatically lock after remote shutdown.
16. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle.
17. Automatic Start Mode. Selects between every two hours or every one hour for the automatic
engine starting feature.
18. Tachless Sense Crank Time. Selecting engine crank time automatically selects the tachless mode
and one of three crank times.
If the normal engine crank time is too short increase the time by selecting one of the two additional
extended crank time options.
Normal - 0.8Sec.
Extended - 1.0Sec.
Super Extended - 1.4Sec.
T
achless Mode. Determines the engine status using an advanced software routine, without requiring
connection to the vehicle’s tachometer. Tachless operation may not be compatible with some vehicles
or in severe temperatures, in which case the tach wire must be connected.
19. Smart Start Temperature Compansation. adjusts crank time to compansate for temerature
variations.
20. Engine Sense Mode. Enable or disable smart sense monitor or if connected select vacuum pump
monitor.
glow plugs are warm before cranking the starter. If the glow plug wire is not connected, the built-in
timer waits 15 seconds before automatically cranking the starter.