Filter
Top Products
Astra 100RS - Page 11
Entering System Programming
To enter System Programming:
1. Turn on ignition.
2. Within 5 seconds, press the valet switch 5 times.
· The parking lights will flash three (3) times indicating you have entered Programming.
3. Press the valet switch the number of times equal to the System Parameter you want to change.
· The parking lights will flash each time the valet switch is pressed.
4. Within 5 seconds, press the Brake Pedal the number of times corresponding to the desired
operating mode for that System Parameter, within two seconds, parking lights will flash to indicate
the setting.
1 flash
2 flashes
3 flashes
5. When you are finished, turn off the ignition to save the changes.
Default Reset
Following this procedure will set all System Programming Parameters to factory default settings.
1. Enter System Programming.
2. Press the Brake Pedal three times.
· The parking lights will flash 6 times indicating that the reset signal was received.
· All System Programming parameters are now set to factory default settings.
· The Valet Mode is off.
3. Turn off ignition.
Programmable System Options
The following is a description of the programming options of the system. Some of the program branches
control more than one option, and may require accessing a particular branch number twice in order to
program all desired features.
1. Reserved.
2. Reserved.
3. Reserved.
4. Reserved.
5. Reserved.
6. Reserved.
7. Start in Valet Mode. Selects if vehicle should start when in Valet.
8. Reserved.
9. Reserved.
10. Engine Run Time. Selects between 15 or 25 minutes for the remote start run cycle.
11. Reserved.
System
Programming