A. Engine Air Cleaner/Filter. See Engine Air
Cleaner/Filter on page 5-17 for more information.
B. Engine Oil Dipstick. See “Checking Engine Oil” under
Engine Oil on page 5-13 for more information.
C. Engine Oil Fill Cap. See “When to Add Engine Oil”
under Engine Oil on page 5-13 for more information.
D. Brake Master Cylinder Reservoir. See “Brake
Fluid” under Brakes on page 5-33 for more
information.
E. Power Steering Fluid. See Power Steering Fluid on
page 5-31 for more information.
F. Battery. See Battery on page 5-36 for more
information.
G. Engine Coolant Recovery Tank. See Cooling System
on page 5-26 for more information.
H. Windshield Washer Fluid Reservoir. See “Adding
Washer Fluid” under Windshield Washer Fluid
on page 5-32 for more information.
Engine Oil
Checking Engine Oil
It is a good idea to check your engine oil every time you
get fuel. In order to get an accurate reading, the oil
must be warm and the vehicle must be on level ground.
The engine oil dipstick handle is a yellow loop. See
Engine Compartment Overview on page 5-12 for
the location of the engine oil dipstick
1. Turn off the engine and give the oil several minutes
to drain back into the oil pan. If you do not do this,
the oil dipstick might not show the actual level.
2. Pull out the dipstick and clean it with a paper towel
or cloth, then push it back in all the way. Remove it
again, keeping the tip down, and check the level.
When to Add Engine Oil
If the oil is at or below the MIN mark, then you will need
to add at least one quart of oil. But you must use the
right kind. This section explains what kind of oil to use.
For engine oil crankcase capacity, see Capacities
and Specifications on page 5-89.
Notice: Do not add too much oil. If your engine
has so much oil that the oil level gets above
the upper mark that shows the proper operating
range, your engine could be damaged.
5-13