W(Unlock): Press this symbol on the remote keyless
entry transmitter to unlock the driver’s door. This also
disarms the theft-deterrent system. See “Theft-Deterrent
System” following for information on disarming the
theft-deterrent system. Press the button again to unlock
the rest of the doors.
Your vehicle can be programmed so that the parking
lamps will flash and/or the horn will sound when you
unlock the doors with the remote keyless entry
transmitter. See your retailer for more information on
programming this feature.
L(Panic Alarm): The remote keyless entry transmitter
comes equipped with an instant panic alarm. Press the
horn symbol when the ignition is turned off. The horn
will sound and the parking lamps and dome lamp
will flash for up to two minutes. To stop the instant
panic alarm, press the symbol again.
V (Trunk): Press this button to open the trunk.
If the vehicle’s speed is faster than 2 mph (3 km/h),
the trunk will not open when this button is pressed.
Theft-Deterrent System
The remote keyless entry transmitter is used to
arm/disarm the theft-deterrent system. Your vehicle’s
theft-deterrent system can be programmed to three
different modes.
Active Arming: The system will arm when the lock
button on the remote keyless entry transmitter is
pressed. The system will disarm when the unlock button
is pressed.
Passive Arming: The system will arm itself one minute
after the ignition is turned off and the driver’s door
has been opened and closed. If the lock button on the
transmitter is pressed before the minute has passed, the
system will arm immediately. The system will disarm
when the unlock button is pressed.
Security System Disable: The system will not arm.
To change the mode that your vehicle is programmed to,
do the following:
1. Turn the ignition to RUN or ACC.
2. Press the panic alarm button on the transmitter
slowly four times within five seconds.
2-6