43
Be careful not to spill water over the remote control, sensor controller, seat, or foot rest.
Otherwise, electric shock, short circuit or fire may occur.
Do not suddenly release your hand, while raising the foot rest.
Otherwise, an injury may occur.
Prior to use, be sure to raise the back pad in order to check that the cover cloth or the cloth of other
parts is not torn. If a tear is found, however small, stop using the massager immediately, unplug the
power source, and obtain service.
If the massager is used with torn cloth, it may result in injury or electric shock.
Use only under careful medical supervision if you have or there is a possibility that you have a
medical condition that may possibly, in any way, be affected by massager.
If discomfort or pain is felt during use, stop using the massager and consult a doctor immediately. In
addition, when the massage force is felt strongly, stop using it earlier than planned.
Otherwise, if the user continues using in such a way, an unexpected accident may occur.
For safety, check the position of the massaging rollers before leaning slowly back on the massager.
Do not twist the body, but lean straight back on the massager, so that the massaging rollers are in
position on either side of the spine.
Otherwise, leaning abruptly on the massager may injure the spine or result in some other injury.
After use, be sure to set the POWER switch to the [OFF] position, and the LOCK switch to the [LOCK]
position.
Otherwise, it may result in accident or injury due to a child's mischief.
Do not use the massager on top of a heated carpet or other heater, or near a stove or other heat
sources.
Otherwise, it may result in fire.
Do not attempt to hang from the back pad or head cover, or pull the back pad or head cover forcibly.
Otherwise, the back pad or head cover may come off, possibly resulting in injury.
Aim to use the massager for up to 20 minutes each time. Limit the use of the massager on one point
to 5 minutes or less.
Otherwise, the continuous use of the massager on one point for an extended period may result in adverse
effects or injury.
Be careful not to fall asleep during massage.
Otherwise, an injury may occur.
Place the massager main unit on a level floor surface.
Otherwise, if it is placed at an unstable place, the main unit may fall over, possibly resulting in injury.
Do not use the massager in the bathroom, or places with high humidity.
Otherwise, electric shock may occur.
Do not place anything other than the remote control and the sensor controller respectively on the
remote control stand.
Otherwise, the stand may break, resulting in injury.
Do not use the massager on bare skin.
Otherwise, an injury may occur.
Do not use for any purposes other than as a massager or as a chair.
Otherwise, an accident or injury may occur.
Avoid use by those who are unable to clearly indicate their intentions, as well as by physically
disabled people.
Otherwise, an injury may occur.
Do not attempt to disconnect the power plug by pulling the cord, but always by holding the power
plug and pulling it out. Also, clean the dust off the power plug periodically.
Otherwise, electric shock, short circuit or fire may occur.
Switch the power [OFF] instantly if there is a power failure, and also pull the power plug out from the
outlet.
Otherwise, it may become dangerous when the power is restored.
Do not move the massager with a person on it.
Otherwise, the massager may fall over, resulting in injury.
At first, do not attempt to recline the seat deeply, lean on the back rest forcibly or massage without
the back pad (until you have become accustomed to massaging).
Otherwise, if the massaging force is too strong at the outset, it may result in adverse effects or injury.
Do not use the massager with other medical instruments (e.g. a low frequency medical instrument).
Otherwise, the user may feel sick or, it may cause other health problems.
If the massager becomes inoperative, disconnect the power plug immediately to prevent accidents,
and ask the sales agent for inspection/repair information.
Otherwise, it may result in fire due to electric shock, current leakage, short circuit, etc.
When the equipment will not be used for an extended period, be sure to disconnect the power plug
from the outlet.
Otherwise, it may result in electric shock, current leakage or fire due to damaged insulation.
WARNING: Connect this appliance to a properly grounded outlet only. See Grounding Instructions.
Grounding Instructions
This product must be grounded. If it should malfunction or breakdown, grounding provides a path of least
resistance for electric current to reduce the risk of electric shock. This product is equipped with a cord
having an equipment-grounding conductor and a grounding plug. The plug must be plugged into an appropriate
outlet that is properly installed and grounded in accordance with all local codes and ordinances.
This product is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug
illustrated in sketch A. A temporary adapter that looks like the adapter illustrated in sketches B and C may
be used to connect this plug to a 2-pole receptacle as shown in sketch B if a properly grounded outlet is
not available. The temporary adapter should be used only until a properly grounded outlet (sketch A) can be
installed by a qualified electrician. The green colored rigid ear, lug, or the like extending from the adapter
must be connected to a permanent ground such as a properly grounded outlet box cover.
Whenever the adapter is used, it must be held in place by a metal screw.
This product is for use on a nominal 120-volt circuit, and has a grounding plug that looks like the plug
illustrated in sketch A. Make sure that the product is connected to an outlet having the same configuration
as the plug. No adapter should be used with this product.
The maximum permissible weight of the user is 264 .
Otherwise, an accident may happen or damage to the machine may result.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
GROUNDING METHODS
Sketch A
GROUNDED
OUTLET
GROUNDING
PIN
GROUND
OUTLET BOX
SAVE THESE INSTRUCTIONS
ADAPTER
METAL
SCREW
TAB FOR
GROUNDING SCREW
Sketch B Sketch C
Do not use the adapter in Canada.