Filter
Top Products
Step 4a: Wiring into the glovebox
Carefully cut a 1” (2.54cm) hole into the glovebox in a logical location. Run the audio and dock cable down through the
radio opening and out the side of the console. Pull these wires through and put them through the hole you’ve cut in the
glove box. Leave approximately 1’ (30.5cm) of cable in the console to allow connections to reach.
Step 4b: Wiring to an external dock
If you’ve procured an iPod mount for your dashboard, you can opt to run the cables out of the console in whatever man-
ner you feel is aesthetically correct to make the connections. Ensure that you leave 1’ (30.5cm) of cable length in the
console to complete the connections to the control unit.
Step 5: Putting it all back together
Once the cables have been run to the respective location, connect the DIN connector (the round one that says Belkin on
it) and audio cable to the AudioTroll. Gently press the new assembly downward and out of the way of the radio’s and
climate control unit’s space. Before refitting the radio into the fascia, refit the antenna lead and position the unit near the
opening in the fascia. Insert the male connector from the harness adapter into the back of the radio unit. Slide radio unit
back into the dashboard until it clicks.
Granite Embedded Systems
AudioTroll 9400/9600 Operation + Installation Manual