Filter
Top Products
163Starting and driving
Automatic
transmission 3
The automatic transmission has an elec-
tronic control module. The control module
receives information including accelerator
position and road speed. Using this and
other information, it controls the hydraulic
pressure of the transmission to ensure that
gear changing is as smooth as possible.
The remote control can only be removed
when the selector lever is in the P position.
The engine can only be started when the
selector lever is in the P or N position.
When the car is stationary, the engine must
be idling when you move the selector lever
from one position to another. If not, the
transmission could be damaged.
WARNING
• Depress the brake pedal when shifting
the selector lever from P or N.
• The car must be at a standstill before
P, R or N is selected. You have to have
your foot on the brake pedal to move
the lever out of P. If the car is still
moving when a drive position is subse-
quently selected, this could cause a
crash or damage the automatic trans-
mission.
• Never park the car with the selector
lever in a drive position, even if the
parking brake is on.
• If you want to leave the car with the
engine running, move the selector
lever to P or N and apply the parking
brake.
NOTICE
After selecting a drive position, pause
briefly to allow the gear to engage (the car
starts to pull a little) before you acceler-
ate.
Selector lever
1 Position for manual gear selection
Indication of gear position on main
instrument panel
93_U S_M 07.book Page 163 W ednesday, April 12, 2006 9:30 AM