Filter
Top Products
GPS-300 Operating Manual
Rikaline
Rikaline International Corp. 10F, 64, Kang-Ding Road, Taipei 108, Taiwan
Tel: ++886 2 2370 4688 Fax: ++886 2 2370 4686 E-Mail: info@rikaline.com.tw
Web: www.rikaline.com.tw
3
0. Quick Use
0.1 Check GPS Package
0.1.1 Standard Package
Main Unit: GPS Receiver and Power Converter built in the housing.
Mounting Accessories: Metal Bracket + 2 Screws (for plastic) Comes Fixed with Glue
Cable Ties x 4 pieces
Velcro (Adhesive Tapes) x 1 Set (When using on the dashboard)
Power Cable: 1.5m with connector & Fuse + Rocker Switch +2m Baring End + A pair Close-end Wire
Connector x 3 Sets in Different Diameter.
External Active Antenna (A-10305-SA): SMA connector, 5m Cable, 26dB Gain
Data Cable (A-6018-C): 1.5m RS-232 with Positioning Status LED.
Miscellaneous: CD + Warranty Card + Quick installation reference.
0.1.2 Optional Package
The shop may bundle different accessories for you as follows:
1. PDA Cable Connector
2. Software (Navigation Software + Digital Map)
3. Others
0.2 Check connector
1. A-6018-C RS-232 Serial Port Connector for PC/Laptop or PC based system.
2. A-6020 USB cable for USB interface PC or PC based system. While connecting with USB Connector,
please install USB driver first.
3. When you connect your PDA to GPS-300, you need an optional cable A-6019 series.
4. Various cables are ready for optional devices.
5. Connect External Active Antenna to GPS-300.
0.3 Plan your installation
You must decide where and how to install the following items separately, then your installation procedure
is different to follow.
1. How and Where to install the main unit:
a. Under instrument cabinet: with cable tie or screw.
b. On dashboard: with velcro (Adhesive Tapes).
2. Active Antenna: on dashboard, roof, top of trunk or in the back.
3. Power Supply: Before or after the ignition switch.
4. Switch: Punch a hole to install it or put it at a suitable place.
5. For PC or PDA.
6. For permanent of temporary use.
0.4 Connect GPS-300 to Car Power.
Be sure to connect car power after IGNITION SWITCH to prevent running out of power if you forget to
switch off GPS-300 when you get off the car. If you like your unit always stays at ON, you may connect
the unit before ignition switch. (Warning: If you do not switch off the unit when you park the car, your
battery will run out of if the unit input power connected before ignition switch.)
0.5 Turn on Your device.
0.6 Your GPS-300 starts to provide you full GPS function.