BEFORE YOU BEGIN
2
WARNING:
DO NOT USE NON-RAZOR
PARTS WITH YOUR
GROUND FORCE DRIFTER.
The Ground Force Drifter has
been built to certain Razor design
specifications. The original
equipment supplied at the time of
sale was selected on the basis of
its compatibility with the frame and
all other parts. Certain aftermarket
components may not be compatible.
Use of non-Razor parts will void the
warranty.
WARNING: Turn power
switch off before conducting any
maintenance procedures.
q Required Tools
(2) 5mm Allen wrench (included)
3mm Allen wrench (not included)
8/10mm open wrench
(not included)
13/17mm wrench
(not included)
Need Help? Visit our web site for replacement parts, product support and a list of authorized service centers
at www.razor.com or call toll-free at 866-467-2967 Monday - Friday 8:00 AM - 5:00 PM Pacific Time.
Remove contents from box. Remove the foam separators that protect the components from damage during
shipping. Inspect the contents of the box for scratches in the paint, dents or kinked cables that may have
occurred during shipping. Because the Ground Force Drifter was 95 percent assembled and packed at the
factory, there should not be any problems, even if the box has a few scars or dents.
Estimated Assembly and Set-Up Time
Razor recommends assembly by an adult.
Allow up to 45 minutes for assembly, not including initial charge time.
Allow up to 12 hours for initial charge (see page 5 for charging information).
ON
OFF
Speed Control / Thumb Throttle
Steering Wheel
Charger Port
On/Off Switch
Tie Rod
Brake Adjustment
(Auxiliary)
Brake Lever
Charger
Charger
Plug
Charger
Port