Filter
Top Products
PAGE 6 OF 11
TN200P WUG v2.0
TN-200
Use this button to open this Users Guide document should you have a need to
reference or print it in the future. To view this Users Guide, you will need to
have Adobe Acrobat Reader installed on your computer.
Use this button to install the GPS utility to verify that your GPS receiver is
functioning properly. Be sure to configure the program with the correct COM
port assigned to your GPS receiver and you are outdoors with a good view
and signal from the sky.
This button will open a Users Guide in .PDF format for Mac users. The
manual provides instructions on how to install and properly configure their
Mac computer for use with the TN-200 GPS receiver.
Use this button to exit and close the setup screen.
Use this button to install Adobe Acrobat Reader 6.0 if you don’t already have it
on your computer.
3. VERIFY COM PORT ASSIGNMENT
To verify the COM port number assigned to your GPS, open the “Control Panel,” click on “System,”
select “Device Manager” and look for the heading “Port (COM & LPT)” and maximize it by clicking on
the “+” sign. You should see “Prolific USB-to-Serial Comm Port” (COMx) with “x” being the assigned
COM port.
NOTE: From within your mapping, or navigation software (including the supplied GPS Information
utility), you will need to manually configure the selection of the COM port to what was assigned to the
GPS receiver so that proper communication between the GPS receiver and mapping program can
occur. Most all software requires that you manually configure the COM port setting for any GPS device
you use.