Filter
Top Products
Chapter 1: SmartPilot Operation 3
When the power supply is switched off, the SmartPilot controller buttons have no
effect.
Notes: (1)
Each time power to the SmartPilot controller is switched on, the control-
ler is initially in the on condition. You do not need to use the
disp
button to switch the controller on.
(2)
When the SmartPilot controller is on, the operation of the
disp
button
will perform other operating functions, as described below.
Start-up mode
The SmartPilot always powers up in Standby mode with the display showing the
boat’s current compass heading.
Note:
You can press
standby
at any time to return to manual steering.
Keypad functions
The SmartPilot is controlled using simple push-button and rotary control
operations, all of which are confirmed with a short beep. In addition to the main
single-button functions, there are several dual-button operations.
D6337-2
mode
rotary control
mode
&
Press to scroll through
calibration parameters.
Press to adjust
response and gain
track
Press for Track mode from Auto mode
(if a navigator is connected)
Press to accept waypoint advance
Press for 1 second to skip waypoint
auto
Press for Auto mode
standby
Press for Standby mode
Press for 2 seconds
to enter Calibration mode
resp
Press to display response level
Press for 1 second for rudder gain
res'm
Press to resume previous course
disp
In Auto mode, turn to
change locked heading.
In Power Steer mode:
turn to steer boat.
press in to center
rudder.
Press to select Power Steer mode
standby plus auto
Press for Wind Vane mode
(if a wind vane is connected)
Press to display
data pages
When powered
down, press for 1
second to power up
Press for 9 seconds
(in Standby mode)
for power down
Press for 1 second
for lamp adjust
Press for 3 seconds
for contrast adjust