Filter
Top Products
30 ST7002 SmartPilot Controller Operating Guide
3.2 General maintenance
Routine checks
CAUTION: Do not dismantle SmartPilot products
The SmartPilot computer and controller do not contain any user
serviceable parts. They should be serviced only by authorized
Raymarine service technicians.
The SmartPilot computer does NOT contain user-serviceable parts. If you remove
the main cover you will invalidate the warranty. The controller is also a sealed
unit, so user maintenance is limited to the following checks
• make sure all cable connectors are firmly attached
• examine for signs of wear or damage – replace any damaged cables
Note:
Do not use chemical or abrasive materials to clean the SmartPilot computer. If the
case is dirty, wipe it with a clean, damp cloth.
Cleaning the display
CAUTION: Avoid damage when cleaning
Take care when cleaning the display. Avoid wiping the display
screen with a dry cloth as this could scratch the screen coating. If
necessary, use only a mild detergent.
• Never use chemical or abrasive materials to clean the controller. If it is dirty,
wipe it with a clean, damp cloth.
• In certain conditions, condensation may appear inside the display screen. This
will not harm the unit, and you can clear it by switching on the illumination for
a short time.
RG FAIL
GyroPlus yaw sensor has failed:
• If you have a S1G, S2G or S3G course computer with internal
GyroPlus sensor – call a Raymarine service agent.
• If you have a Non-G
s
course computer with external GyroPlus
yaw sensor – check the sensor and connections, then call a Ray-
marine service agent.
SEATALK and
FAIL 1 or 2
SeaTalk data problem on one of the SeaTalk lines – check connec-
tions.
SEATALK and FAIL
The control unit cannot transmit data to the SeaTalk system. Make
sure all SeaTalk cables are connected properly.
ALARM MESSAGE POSSIBLE CAUSE and SOLUTION