Filter
Top Products
Raystar 112LP GPS Transducer Installation
Pole/Rail Mounting
1. Screw the pole mount base to a suitable pole or rail mount bracket
which has an industry standard 1” 14TPI thread until secure.
2. Pass the cable through the centre hole of the pole mount base (A)
or through the cable exit hole alongside the centre hole (B) or
insert the cable into the side exit channel (C).
3. Check the cable is positioned correctly and secure the receiver to
the pole base using the two screws provided.
Note: An optional Rail mount bracket is available from Raytheon
(Part No. D360) allowing attachment to hand/guard rails from 19mm
(3/4”) to 25mm (1in).
D4191-1