Filter
Top Products
3
Use the template supplied in this handbook to
mark the two fixing holes and the center hole.
Drill the holes using the drill sizes shown on
the template.
Screw the two fixing studs into the underside
of the receiver unit.
Place the waterproof gasket into position on
the underside of the receiver.
Attach the connector securely to the plug in
the base of the unit and pass the cable
through the center hole on the mounting
surface.
Carefully position the receiver so that the
mounting studs pass through the holes in the
mounting surface.
Secure the receiver to the mounting surface
using the two thumb nuts (these should be
hand-tight only).
1
2
3
4
5
6
7
5
3
7
4
b
1
3
2
4
a
Securely attach the pole mount base to a
suitable pole.
Pass the cable and connector through either
the center of the pole mount bracket and
the pole, or
the cable exit hole alongside the center
hole.
Attach the connector securely to the plug in
the base of the unit.
Secure the receiver to the pole mount base
using the screws provided.
1
2
3
4
a
b
To mount the unit on a pole....
To flush mount the unit....
D7473_2
Notes:
1. To mount the receiver on a pole, you will need
a pole of suitable length with a 1 inch 14 TPI
thread not exceeding 20mm in length.
2. To rail mount the receiver you will need to
purchase a suitable rail mount bracket