Filter
Top Products
15
Operation
Muting the Audio Alert
When the detector sounds a radar or safety alert signal, press
MUTE
to temporarily silence the detector. When you press
MUTE
,
M
appears. The detector resets
MUTE
to go off 20 sec-
onds after the signal stops. Or, press
MUTE
again before it re-
sets, and
M
disappears. The laser alert signal remains audible
even if you press
MUTE
.
Selecting VG-2 Mode
VG-2 mode is preset to off. To turn on VG-2, hold down
MUTE
until
VG2-ON
appears. To turn VG-2 off, hold down
MUTE
until
VG2-OFF
appears.
Note:
If there is another detector nearby, you might receive
false signals. To avoid receiving such signals, turn VG-2 off.
RECEIVING AND IDENTIFYING RADAR,
LASER, AND SAFETY ALERT SIGNALS
When your detector senses a radar signal,
X
,
K
, or
KA
appears.
An alert tone for the type of band detected sounds, and the dis-
play shows the signal strength in numeric form.
Note:
The closer you get to the source of the radar, the higher
the signal strength number.
When your detector senses an instant-on signal,
INSTANT
-
ON
appears and the instant-on alert tone sounds.
When your detector senses a laser signal,
LASER
flashes and
the laser alert tone sounds.