Python 991 Remote Starter User Manual


  Open as PDF
of 60
 
42
© 2008 Directed Electronics. All rights reserved.
Note:
Bypass Notification does not occur when the system is in Silent
Mode or if the notification chirps have been programmed off by the
installer.
Disarming
%XTRACHIRPSHEARDWHENDISARMINGTHESYSTEMARETHE4AMPER!LERT
If four chirps are heard when disarming the system, then the security
system was triggered in your absence.
If five chirps are heard when disarming the system, the system was
TRIGGEREDSOMANYTIMESTHATTHE.UISANCE0ROTECTION#IRCUITRYHAS
bypassed the intended zone. In either case, the status LED will indicate
which zone was involved (see Table of Zones).
The security system will retain this information in its memory, and chirp
FOURORlVETIMESEACHTIMEITISDISARMEDUNTILTHENEXTTIMETHATTHE
ignition is turned on.
Note concerning low battery alert:
When the batteries in the remote
are low the alarm will give an additional chirp when disarming to let
you know its time to change the battery in the remote.
System status chirps
4HESIRENWILLCHIRPWHENARMINGDISARMINGTHESYSTEM4HEPATTERNOF
chirps will audibly report the system’s status as described below.
Action Number of Chirps Description
Arm 1 System armed
Arm 1 (3-second delay) + 1 System armed with bypass notification
Disarm 2 System disarmed
 previous next