Python 991 Remote Starter User Manual


  Open as PDF
of 60
 
19
© 2008 Directed Electronics. All rights reserved.
minutes and 1 minute of runtime remaining, it sends the 2-way remote
control a paging signal.
Points to remember
:
If the hood is open or if the brake pedal is pressed, the vehicle will not
remote start.
The remote start shuts down:
When the brake pedal is pressed.s
The hood is opened.s
When the remote start command is sent again from a remote s
control.
7HENTHERUNTIMEEXPIRESs
To drive your vehicle after it has been remote started:
'ETINWITHOUTSTEPPINGONTHEBRAKE1.
Insert the ignition key and turn it to the ON position.2.
Now, step on the brake. 3.
The remote control will play the remote start shutdown tone. You have
now taken direct control from the remote start system.
Valet Take-Over
4HE6ALET4AKE/VERFEATUREALLOWSTHEVEHICLETOREMAINRUNNINGAFTER
the key has been removed from the ignition. This feature is useful for
OCCASIONSWHENYOUWISHTOEXITANDLOCKTHEVEHICLEFORSHORTPERIODS
of time, but would like to leave the motor running and the climate
controls on.
4OENABLE6ALETTAKEOVERWHILETHEVEHICLEISRUNNINGPRESS 1 time
and the parking lights will flash after a couple of seconds turn off the
IGNITIONANDTHECARSHOULDSTAYRUNNING/NCEYOUEXITTHEVEHICLEYOU
can lock the system and the car will remain running. If the vehicle shuts
down, then the unit did not enter valet take-over mode.
 previous next