Filter
Top Products
9
©
2006 Directed Electronics—all rights reserved
■ After the remote start module has been installed, contact your
authorized dealer to have him or her test the remote start
module by performing the Safety Check outlined in the prod-
uct installation guide. If the vehicle starts when performing
the Neutral Safety Shutdown Circuit test, the remote start unit
has not been properly installed. The remote start module must
be removed or the installer must properly reinstall the remote
start system so that the vehicle does not start in gear. All
installations must be performed by an authorized Directed
Electronics dealer. OPERATION OF THE REMOTE START MOD-
ULE IF THE VEHICLE STARTS IN GEAR IS CONTRARY TO ITS
INTENDED MODE OF OPERATION. OPERATING THE REMOTE
START SYSTEM UNDER THESE CONDITIONS MAY RESULT IN
PROPERTY DAMAGE OR PERSONAL INJURY. YOU MUST IMME-
DIATELY CEASE THE USE OF THE UNIT AND SEEK THE ASSIS-
TANCE OF AN AUTHORIZED DIRECTED ELECTRONICS DEALER
TO REPAIR OR DISCONNECT THE INSTALLED REMOTE START
MODULE. DIRECTED ELECTRONICS WILL NOT BE HELD
RESPONSIBLE OR PAY FOR INSTALLATION OR REINSTALLA-
TION COSTS.
Pressing for one second arms the system by activating the
starter kill and locking the doors (if the door locks are connected).
The horn will honk (if connected) and the parking lights will flash
once to confirm arming of the system. While the system is armed,
the status LED will flash once per second. The Failsafe
®
Starter Kill
(if installed) will also prevent the vehicle’s starter from cranking.
Arming