Filter
Top Products
6-37
4. Disconnect the bulb
base from the socket
by lifting the plastic
locking tab.
5. Snap a new bulb into the socket.
6. Reinstall the bulb assembly by reversing Steps 1
through 3, making sure the lower leg of the
headlamp bracket is properly seated into the
wedge
-shaped retainer.
Center High-Mounted Stoplamp (CHMSL)
(Models Without a Spoiler)
To change the bulb, do the following:
1. Open the trunk and view the access hole under the
rear shelf.
2. Remove the bulb socket by twisting it in either
direction, then pull down.
3. Remove the bulb and replace it.
4. Reinstall the bulb socket into the CHMSL.
Center High-Mounted Stoplamp (CHMSL)
(Models With a Spoiler)
To change the bulb, do the following:
1. Unscrew the bulb assembly from the spoiler.
2. Gently pull out the bulb assembly.
3. Remove the bulb(s) by gently wiggling the bulb(s)
from the assembly.
4. Replace the bulb(s) and reverse these steps to
reinstall the bulb assembly.