Filter
Top Products
3-12
4 FWD (Forward): Press this button to advance
quickly to another part of the tape. FWD will appear on
the display. Press the button again to return to playing
speed. The radio will play the last selected station while
the tape advances. You may select stations during
forward operation by using TUNE or SEEK.
5 SIDE: Press this button to play the other side of
the tape.
6 RPT (Repeat): Press this button once to hear a
selection over again. RPT will appear on the display.
The current selection will continue to repeat. RPT will
flash on the display while the cassette player is
searching for the start of the selection. Your tape must
have at least three seconds of silence between each
selection for RPT to work. Press this button again to
turn off repeated play. OFF will appear on the display.
AM FM: Press this button to listen to the radio when a
tape is playing. The tape will stop but remain in the
player. The inactive tape will remain safely inside the
radio for future listening.
TAPE: Press this button to play a cassette tape when
listening to the radio. CAS will appear on the display.
(Eject): Press this button to eject a tape. Eject may
be activated with the radio off. Cassette tapes may be
loaded with the radio and vehicle off if this button is
pressed first.
Cassette Tape Messages
If an error appears while trying to play a cassette tape, it
could be one of the following:
ERR (Error): If the player detects a tight or broken
tape, ERR will appear on the display and the player will
eject the tape. The radio will go back to playing the last
station selected.
CLN (Clean): If this message appears on the display,
the cassette tape player needs to be cleaned. It will still
play tapes, but you should clean it as soon as possible to
prevent damage to the tapes and player. See “Care of
Your Cassette Tape Player” in the Index.