Filter
Top Products
73
OPERATION
Starting the Engine
1. Turn the key to the ON position.
NOTICE: Engaging the starter when the engine is running WILL result in serious
engine damage, especially if the transmission is in reverse. Never
engage the starter when the engine is running.
2. Pull the engine stop switch up to the RUN position.
3. Do not apply throttle when starting the engine unless extremely cold
temperatures (below -15° F/-26° C) prevent the engine from start-
ing.
Tip: Under these conditions, attempt to start the engine without using the throt-
tle. If two to three attempts are unsuccessful, apply 1/8 to 1/4 throttle while
cranking the engine. Ease off the throttle immediately when the engine
starts. Continue to apply just enough throttle to keep the engine running
until it idles smoothly.
4. Turn the key to START to crank the engine. Release the key to the
ON position when the engine starts.
5. Repeat the cranking procedure as needed until the engine starts.
Tip: Always allow the engine to warm up to full operating temperature (150° F/
65° C) before shutting it down. Avoid starting and stopping the engine with
less than 5 minutes of run time when the engine is cold.