Filter
Top Products
44
FEATURES
All Wheel D rive (AWD) System
Engaging Front Gearcase
The AWD switch may be turned on or off while the vehicle is moving.
Initially, the vehicle’s electronic system will not enable the AWD until
the engine RPM is below 3100. Once enabled, the AWD remains
enabled until the AWD switch is turned off. If the switch is turned off
while the front gearcase is moving, it will not disengage until the rear
wheels regain traction.
Engage the AWD switch before getting into conditions where front
wheel drive may be needed. If the rear wheels are spinning, release the
throttle before switching to AWD.
CAUTION
Switching to AWD (or from TURF to 2X4) while the rear wheels
are spinning may cause severe drive shaft and gearcase
damage. Always switch to AWD (or to TURF from 2X4) while the
rear wheels have traction or are at rest.
Passenger Seat
Always make sure the passenger seat lock-out is functioning properly
before operating with a passenger.
Do not operate the vehicle with the seat in the 2-up position when
operating without a passenger. Always return the seat to the 1-up
position for single-rider operation.
Never carry cargo in the rear box when operating the ATV in the 2-up
mode
with a passenger.
Seat Conversion
1. Make sure the cargo box
dump lever (A) is securely
latched.
2. Lift the latch (B) at the
top of the operator
backrest and tilt the
backrest slightly forward.
3. Pull the passenger seat
backrest (C) upward from
the bed of the cargo box.
B
C
A