Filter
Top Products
57
OPERATION
Break-In Period
4-Cycle Engines
The break-in period for your new Polaris ATV is defined as the first ten
hours of operation, or the time it takes to use the first two full tanks of
gasoline. No single action on your part is as important as following
the procedures for a proper break-in. Careful treatment of a new
engine will result in more efficient performance and longer life for the
engine. Perform the following procedures carefully.
1. Fill the fuel tank with
gasoline. See page 43.
2. Check the oil level on
the dipstick. See page
98. Add Polaris
Premium 4 Synthetic Oil if
necessary to maintain the oil
level in the normal (safe)
operating range (1).
3. Drive slowly at first. Select an
open area that allows room to familiarize yourself with vehicle
operation and handling.
4. Vary throttle positions. Do not operate at sustained idle.
5. Perform regular checks on fluid levels, controls and areas outlined
on the daily pre-ride inspection checklist. See page 58.
6. Pull only light loads.
7. During the break-in period, change both the oil and the filter at 20
hours or 200 miles.
CAUTION
Excessive heat build- up during the first three hours of operation will
damage close-fitted engine parts. Do not operate at full throttle or
high speeds for extended periods during the first three hours of
use.
Use of any oils other than those recommended by Polaris may
cause serious engine damage. We recommend the use of Polaris
Premium 4 Synthetic Oil for your 4-cycle engine.
ADD 8 OZ. NORMAL FULL
1
1