Filter
Top Products
42
FEATURES
Instrumentation
MFD Settings
The MFD control switch allows you
to set the MFD display to your pref-
erences. The rocker switch has a
MODE button (top) and a SET but-
ton (bottom). Specific instructions
are outlined on the following pages.
MFD settings can be made with the
engine running or with the engine
off. If the engine is off, make sure
the stop switch is pressed down, and
turn the ignition key to the START
position briefly to activate the
gauge. The gauge will illuminate for about 90 seconds.
Standard vs. Metric
The MFD will display either standard or metric units of measurement.
While viewing a screen that displays measurements (MPH, km/h or
temperatures), press and hold the MODE switch until the unit of mea-
surement changes (about 10 seconds).
ACE Suspension Adjustment (FST Cruiser)
The MFD control switch also operates the M-10 ACE rear suspension
adjustment. When the blue ACE adjustment switch on the console is in
the GAUGE position, the MFD control switch functions the same as on
all other FST models. When the switch is in the ACE position, you may
use the MFD control switch to adjust the rear suspension. See page 71
for instructions.
NOTE: The engine must be running to make suspension adjustments with the
MFD control switch.
MFD Control Switch
SET
MODE