Filter
Top Products
25
FEATURES AND CONTROLS
Seat
Seat Load Adjustment
Adjust the seat spring for the comfort
of a lighter or heavier operator. Reach
under the rear rack to access the
adjuster. Tighten the spring for heavier
riders. Loosen the spring for lighter rid-
ers.
Use the following table to determine
the best preload measurement for rider
weight. Measure preload between the
adjuster plate and the lower spring
retainer.
Seat Removal
Lift the latch bar at the rear of the seat to
release the latch. Tilt the seat slightly rear-
ward to disengage the seat tabs from the
rear seat base slots. Remove the seat.
Make sure the seat is securely installed
before operating.
Seat Height Adjustment
To raise or lower the seat, remove the seat
and reposition the seat tabs in one of the
rear seat base slots. Make sure the seat is
securely installed before operating.
Backrest Adjustment
Loosen the backrest knobs on each side of
the backrest mount and slide the backrest
forward or rearward to the desired posi-
tion. Tighten the knobs securely.
Rider Weight
Preload
Measurement
Up to 39 kg 0 mm
39-94 kg 0-32 mm
Over 94 kg 32-64 mm
Driver's seat, type Seat One:
e11*78/764*2006/96*2056*00
Load Adjuster
Measure Preload
(shown with seat removed)
Height Adjustment Slots
Backrest Knobs