Filter
Top Products
21
FEATURES AND CONTROLS
Switches
Main Key Switch
End all electrical power to the vehicle.
The LIGHTS ON position turns the headlights
on. The master light switch must be on and the
engine stop switch must be in the RUN position.
Start the engine. The headlights are not on in
this position.
After starting the engine, release the key switch to the PARKING
LIGHTS ON position. The headlights and taillights are on in this
position.
Do not attach a large key fob or key ring to the main switch. It may contact the
gas tank cap when turning, causing an interruption to the electrical system and
an unexpected engine shut-down during operation. This could result in serious
injury or death.
Engine Stop Switch
The engine will not start or run when
the switch is in the OFF position.
OFF (STOP)
RUN
Light Switch (High/Low Beam)
Use the light switch to change the
headlights from high beam to low
beam. The master light switch must
be on to operate the headlights.
High Beam
Low Beam
Engine
Stop Switch
Light
Switch