Filter
Top Products
27
FEATURES AND CONTROLS
Switches
Headlight Switch
Use the headlight switch to turn the lights on and off. The key must be in
the ON position and the engine stop switch must be in the RUN position
to operate the headlights.
All Wheel Drive Switch
See page 35 for all wheel drive information.
Throttle Lever
Operating an ATV with sticking or improperly operating throttle controls could
cause an accident. Never start or operate an ATV that has a sticking or
improperly operating throttle. Always contact your dealer for service before
operating the vehicle.
Failure to check or maintain proper operation of the throttle system can result in
an accident if the throttle lever sticks during operation. Always check the lever
for free movement and return before starting the engine. Also check
occasionally during operation.
Modifications to the electronic throttle control could result in failure to perform as
designed, which could result in an accident. Do not attempt to modify the throttle
control system or replace it with any after market throttle mechanisms. Always
ensure that the throttle cable is installed and properly routed to the throttle
control.
Engine speed and vehicle move-
ment are controlled by pressing the
throttle lever. The throttle lever is
spring loaded. Engine speed returns
to idle when the lever is released.
This ATV is equipped with Polaris
Electronic Throttle Control (ETC),
which is designed to reduce the risk
of a frozen or stuck throttle. If the throttle cable should stick in an open
position when the operator releases the throttle lever, the engine will
stop, and power to the rear wheels will cease.
WARNING