Filter
Top Products
64
MAINTENANCE
Lubrication Recommendations
Always check and change fluids and lubricate greaseable components
at the intervals outlined in the Periodic Maintenance Chart beginning
on page 60. Items not listed in the chart should be lubricated at the
General Lubrication interval.
NOTE: The a-arms and lower control arms are lubricated at the
factory, and no additional lubrication will be needed.
However , if these components are subjected to severe use,
grease zerks have been provided for additional lubrication at
the user’s discretion.
Lubrication Chart Key
" More often under severe use, such as wet or dusty conditions
L Polaris Premium All Season Grease or grease conforming to NLG
No. 2, such as Conoco Superlube M or Mobilegrease Special
F Use Polaris Premium U-Joint Lube every 500 miles, before long
periods of storage, or after pressure washing or submerging
∆ When suspension action becomes stiff, or after washing
Item Lube Method
Engine Oil P S-4 PLUS Performance
Synthetic 2W-50
Add to proper level on dipstick.
Brakes DOT 4 fluid only Maintain level between fill lines.
See page 35.
Drive chain(s) O-ring chain lube or SAE
80/90
Lubricate.
(1) Transmission AGL Synthetic
Gearcase Lube
Maintain as recommended on
page 70.
(2) Swing Arm Bush-
ings
"L Grease
Locate fittings on swing arm and
grease with grease gun.
(3) Tie Rod Ends
"L∆ Grease
Lift boot, clean away dirt and
grease, apply fresh grease by
hand and reassemble.
(4) Axle Housing
"L Grease
Locate fittings on swing arm and
grease with grease gun.