Filter
Top Products
93
MAINTENANCE
Brakes
Bleeding the Hydraulic Brake System
Air in the hydraulic brake system will cause spongy brake lever action.
Bleed the system before operating the snowmobile.
During the bleeding procedure, keep t he brake handle as level as
possible. The reservoir must be in this position to minimize the
possibility of air entering the system through the reservoir vent.
1. Remove brake master cylinder reservoir cover and gasket.
2. Fill the master cylinder reservoir to between the MIN and MAX
marks. Reinstall the gasket and cover.
3. Slip a rubber tube over the ball of the bleedervalve anddirect theflow
of fluid into an approved container.
4. Squeeze the brake lever a full stroke. Then unscrew the bleeder valve
3/4 of a turn to release air.
5. Close the bleeder valve and release the brake lever.
6. Repeat steps 4 and 5 until fluid flows from the bleeder valve in a solid
stream free of air bubbles.
7. After bleeding is complete, refill the reservoir to the proper level. See
page 92.
8. Reinstall the gasket and cover.
Operating the vehicle with a spongy brake lever can result in
loss of brakes, which could cause an accident and lead to
serious injury or death. Never operate the vehicle with a
spongy-feeling brake lever.
WARNING
Overfilling the master cylinder leaves no room for fluid expansion
and may cause the brakes to lock, resulting in serious injury or
death. Always add brake fluid to the fill line as recommended.
WARNING