Filter
Top Products
49
PRE-RIDE INSPECTIONS
Before Starting the Engine
Hydraulic Brakes
Properly functioning brakes
are critical to your safety.
Always check the following
items to assure proper
operation before starting the
engine.
Brake Lever Travel
When the brake lever is
squeezed, it should move no
closer to the handgrip than
1/2″ (1.3 cm) (A). A
distance less t han this indicates l ow brake fluid l evel or air in the
hydraulic system . Refer to the brake bleeding information on page 93.
Lever Feel
A hydraulic system multiplies the force of your hand squeezing the
brake lever. Proper operation depends on an adequate supply of air and
moisture-free hydraulic brake fluid in the system. If t he bra ke le ver
feels “spongy” when squeezed, check the level and condition of the
fluid. Also check for the presence of air in the fluid system. R efer to
page 93 for more information, or see your dealer for service.
Replace brake fluid at least every two years with Polaris DOT 3 high
temperature brake fluid. All DOT 3 brake fluid is not alike. Use only
Polaris brake fluid. See page 112 for the part numbers of Polaris
products.
A
Continued use of “ spongy” brakes may cause a complete
loss of brakes, which could result in serious injury or death.
Always have the brakes serviced at the first sign of
sponginess.
WARNING