Filter
Top Products
63
MAINTENANCE AND LUBRICATION
Lubrication Recommendations
Check and lubricate all components at the intervals outlined in the
Periodic Maintenance Chart beginning on page 60. Items not listed in
the chart should be lubricated at the General Lubrication interval.
NOTE: The a-arms and lower control arms are lubricated at the
factory, and no additional lubrication will be needed.
However , if these components are subjected to severe use,
grease zerks have been provided for additional lubrication at
the user’s discretion.
Lubrication Chart Key
" More often under severe use, such as wet or dusty conditions
L Polaris Premium All Season Grease or grease conforming to NLG
No. 2, such as Conoco Superlube M or Mobilegrease Special
Item Lube Method
4-Cycle Engine Polaris Premium 4 Synthetic 0W40 Add to proper level on dip-
stick.
Brakes DOT 4 fluid only Maintain level between fill
lines. See page 33.
Drive chain(s) O-ring chain lube or SAE 80/90 Lubricate as o ften as re-
quired and before each ride
in wet conditions
Transmission Polaris Premium AGL Synthetic
Gearcase Lube
See Page 66.
(1) Ball Joint
"L Grease
Locate fitting on back side of
struts and grease with
grease gun.
(2) Swing Arm
Bushings
"L Grease
Locate fittings on swing arm
and grease with grease gun.
(3) Axle Housing
"L Grease
Locate fittings on swing arm
and grease with grease gun.
(1)
(2)
(3)