Polaris 6X6 700 EFI Offroad Vehicle User Manual


 
56
OPERATION
All Wheel Drive (AWD)
The illuminated amber AWD
switch indicates that the vehicle is
in AWD.
When the AWD switch is on, the
front wheels will automatically
engage any time the rear wheels
lose traction. When the rear wheels
regain traction, the front wheels
will automatically disengage.
There is no limit to the length of
time the vehicle may remain in
AWD.
When the RANGER 6X6 AWD switch is in the off position, the vehicle
is in two-wheel drive at all times.
When the RANGER 4X4 AWD switch is in the off position, the differen-
tial is open and the vehicle is in one-wheel drive for operation on turf or
when active traction is not needed. When the AWD switch is in the cen-
ter position the differential is locked and the vehicle is in two-wheel
drive. See page 55.
The AWD switch may be turned on or off while the vehicle is moving. If
the switch is turned off while the front hubs are driving, they will not
release until the rear wheels regain traction.
Disengaging AWD
Under certain conditions, it may be possible for the front gearcase to
remain locked unnecessarily. This condition causes increased steering
effort and some vehicle speed restriction. If the front gearcase remains
locked after following these instructions, return the vehicle to your
dealer for service.
1. Stop the vehicle.
2. Operate in reverse for at least 10 feet.
3. Stop completely.
4. Shift into low gear and drive forward.
CAUTION
Switching to AWD while the rear wheels are spinning may cause severe drive
shaft and clutch damage. Always switch to AWD while the rear wheels have
traction or are at rest.
AWD Switch