Filter
Top Products
37
FEATURES AND CONTROLS
Switches
Ignition Switch
The ignition switch
is a three-position,
key-operated switch.
The key can be
removed from the
switch when it is in
the OFF position.
Light Switch
The ignition switch key must be in the ON/RUN
position to operate the headlights. The light switch
has three positions: high beam, low beam and off.
AWD/Differential Lock Switch
The AWD/Differential Switch has three positions:
All Wheel Drive (AWD), Differential Lock/Two
Wheel Drive (2WD) and Off (1WD/turf mode).
Press the top of the rocker switch to engage All
Wheel Drive (AWD). See page 56 for AWD oper-
ating instructions.
Move the rocker switch to the center position
(4X4 models) to lock the differential and operate
in two wheel drive (2WD). See page 55 for Differ-
ential Lock operating instructions.
Press the bottom of the switch to unlock the differ-
ential and allow the rear drive wheels to operate
independently (1WD). This mode of operation is
well suited to turf driving or when active traction
is not needed.
WARNING
Leaving the keys in the ignition can lead to unauthorized use of the vehicle
resulting in serious injury or death. Always remove the ignition key when the
vehicle is not in use.
OFF The engine is off. Electrical circuits are off, except Acc, 12V.
ON Electrical circuits are on. Electrical equipment can be used.
START Turn the key to the START position to engage the electric starter.
The key returns to the ON position when released.
Light Switch
AWD/Differential
Switch
(if equipped)
Ignition Switch
High
Beam
Low
Beam
OFF
AWD
2WD
OFF