Filter
Top Products
59
MAINTENANCE
Emission Control Information
Any qualified repair shop or qualified person may maintain, replace, or
repair the emission control devices or systems on your snowmobile.
Emission Con t rol L abel
Your snowmobile is equipped at the time of sale with an emission
control information (ECI) label and a factory-installed emissions
information hangtag. These items are required by U.S. Environmental
Protection Agency regulations. The ECI label is permanently affixed to
either the right side of the tunnel or the engine recoil cover. The ECI
label should not be removed, even after you purchase the snowmobile.
You may remove the factory-installed emissions information hangtag,
which is i ntended solely for your use in making a purchasing decision.
Emission Control Maintenance Requirements
Your snowmobile is certified to operate on gasoline with a minimum
octane level of 91 (R+M)/2 for the 600 IQ Racer and 87 (R+M)/2 for
the 600RR. The emission control system designation per SAE J1930 is
EM. If your snowmobile is equipped with a check engine light and it
comes on, you must take your snowmobile to a qualified dealer for
diagnostic service. Specifications and adjustments for engine tune-ups
are located in the Service Manual, which is available to your qualified
service technician. Reverse (if equipped) must not be engaged during
engine tune-ups.
Owner ’s Responsibilities
Please read the Snowmobile Engine Emissions Limited Warranty on
page 111, and read the maintenance section of your owner’s manual.
You are responsible for ensuring that the specified maintenance is
performed.
Polaris recommends that you contact an authorized Polaris dealer to
perform any service that may be necessary.